When installing floor tile in your home, you shouldn’t be preoccupied by the layout of the tile you will install only, but it is also very important to prepare the areas so that this project can be done perfectly. Floor tile is an investment in your home since you may not need to change it regularly, but keep it for many years, instead. So, when you are doing the steps of how to lay floor tile, pay attention about how you can prepare the area so that everything will go as you want.
Before installing new flooring, you need to remove the baseboards, moldings and any existing floor coverings on your floors. When removing, make sure that the floor is stable and doesn’t flex. Since floor tiles are hard, you have to make sure the base is not bending so that the floor tile can be kept over time. If your floor gives sound when you walk over, then you need to stabilize it first before installing. How to lay floor tile is also affected by the stabilization, so you can set and add nails to the existing subfloor, sister the floor joists underneath and add bridging between the joists.
Once the floor stabilized, you can install cement backer board and fasten it with recommended glue from the manufacturer. After that, nail the baker board to the floor joists with two inch galvanized nails. Make sure that the doors will able to open over the new floor and put a tile on top a piece of backer board. See if the door can open over the new height or trim the bottom of the door if it can’t be opened. The last, don’t forget to clean all dust and debris to lay down the tiles. After preparing the area, then how to lay floor tile can be successfully done because the area needed has been prepared well.