Remodeling your kitchen shouldn’t be expensive because you can simply replace the door of your cabinet to create a new look in your kitchen design. Replacing your kitchen cabinet door shouldn’t mean that you have to buy new doors because you can make them your own. How to make cabinet doors is not simple, but you can use some instructions here to make your own cabinet doors.
First, you can cut the door sides and stiles equal to the height of the door and the rails, the top and the bottom equal with the door width. After that, attach an auxiliary fence to the table saw and feed a rail face down into the blades. Turn them over and feed rail into blades again. Set the dado head at ½ inch and turn rail on its side, run into blades. Turnover and repeat the step, now you have a “tendon check” on each end of the rail, so you can repeat the step with the other rail. After that. How to make cabinet doors can be continued by drilling a series of holes on the inside edge of each stile in 11/4 inch deep and 1/5 inch in diameter, ½ inch from the ends. Form the mortises by cleaning out with chisel and cut grooves in the sides of each stile between the mortises with a ¼-inch cutter in a router.
Set the table saw blade at 1degree angle to make a raised panel and run it against the auxiliary fence on edge. Repeat this step for all four edges and set the blade at 90 degrees. Adjust the height of the blade to depth of groove on the rails and stiles and run the blade over on all four edges, then sand edges smooth. Squeeze wood glue to the grooves and mortises, set the door panels into grooves, assemble the rails and stiles and hold together until the glue dries. Those are some steps of how to make cabinet doors you can do to remodel the look of your kitchen.